Platform notes EZR32LG_WSTK6200a

To use the default UART using Breakout pad P4 (TX) and P6 (RX):

  • PLATFORM_CONSOLE_UART 0
  • PLATFORM_CONSOLE_LOCATION 1

Connect P4 to Yellow wire of FTDI connector Connect P6 to Red wire of FTDI connector (if this wire is connected, make sure you keep the board powered) Connect GND to Black wire of the FTDI connector You can power the boad using the Red wire of the FTDI using the 5V (!) pin of the dev kit.

To use the VCOM (use ethernet port and telnet (port 4901)):

  • PLATFORM_CONSOLE_UART 3
  • PLATFORM_CONSOLE_LOCATION 1
  • PLATFORM_USE_VCOM ENABLE

initSensors() will initialize the Humidity and Temperature sensor on the devkit. After initialization the values can be read using getHumidityAndTemperature()


Improve this page